-----Original Message-----
From: Jay [mailto:
synthbaron@...]
Sent: Monday, March 28, 2005 11:44 PM
The DotCom has a similar cut, although it looks to be a bit shallower. But
the one MOTM module I own (490) fits fine in the lower portion with JUST
ENOUGH room for the jacks and wires. It looks like there's enough clearance,
from the board pictures I've seen on your site, so that that any "official"
MOTM module would fit.
The 490 mounts on a Stooge products 3 pot short bracket. Many MOTM products
have a bracket that is just as deep, but is 1.625 inches taller. Since the
top placement is the same for both, the 1.625 inches is in the downward
direction. To determine if the 3 pot long bracket will fit, extend an
imaginary line straight back from the bottom of the bracket 2.75" and see if
that hits the bottom of the dot com cabinet.
Larry