Archive of the former Yahoo!Groups mailing list: MOTM
Subject: I can't get my 300 to track 1v/oct. HELP!
From: "earthtodylan2000" <sir_dss@...>
Date: 2005-03-02
Hi,
Can someone help me with this. I had been using a quality strobe
tuner to adjust the trim pot and it just never seemed to lock in
anywhere close to the 1v/oct. It was almost like microtuning when it
tried to match it up with my 310(that track perfectly). A C above
the one I tuned it to would have all the beating next to the one was
correct. Same with the ones below. I did take my time and follow
directions too.
Is there some resistor(s) or cap value that I should check over? I
did do a board check and it looked fine. Maybe an orange band looks
like a red one.
Thanks