Here they are!!!
> Who proposed the original name for MOTM (Hint: It was a women.)?
Dan Higdon's wife
> When was it proposed?
September 10, 1997 (publicly, perhaps a day or two before privately)
> What were the original initials that were proposed?
MoM
> What was the ∗initial∗ form factor MOTM was based on (Hint: It was not the final decision.)?
Digisound
> What was the planned first module called? What functions would be on board (Hint: It never
> went into production.)?
"General Purpose Processing Module"
∗ precision sample/hold
∗ noise generator
∗ ring modulator with built-in mic pre-amp
∗ undedicated VCA
> What noted synth personality helped design the VCO?
Doug Curtis (although I don't know to what degree). I don't know if any of the fruit of this
joint effort ended up in the MOTM-300 or not ultimately. I do know ∗A LOT∗ of ideas were kicked
around and the initial limited-run design was CEM3340 based (later discarded).
--Shemp
__________________________________
Do you Yahoo!?
New and Improved Yahoo! Mail - Send 10MB messages!
http://promotions.yahoo.com/new_mail