> Message: 1
> Date: Thu, 12 Aug 2004 20:27:54 -0000
> From: "elherbus" <jvasche@...>
> Subject: Analogue Systems to MOTM format?
>
> Hi everyone,
>
> How difficult is it to convert AS modules to MOTM format? (I'm
> intrigued by the RS310 reverb/chorus...) I assume that in addition
> to the wiring for pots and jacks I would have to change the power
> connector, but I don't know what else would be involved. Looking at
> their website, it doesn't appear that the modules are offered as
> kits, only preassembled. Is this going to be a huge headache?
I have a custom circuit board designed specifically for this
called the Cynthia Euro'Dapter Card.
It has a combination of mechanical and electronic courtesies that
make my custom module adaptations to Modcan & Cynthia format a breeze!
They' work just fine for MOTM Panels as well!
It is 2x6 inch card with a pair of 12 volt regulators, and a 5 volt
regulator, and converts the board mounted 4-pin
MOTM/Blacet/Oakley/EFM/Encore power connector with (+/- 15 VDC) to the
Analogue Systems type power connector with (+/- 12 VDC and 5 VDC).
It also has power connectors for Doepfer, Analog Sys, Analog Sol,
Modcan, Serge, and Arrick so it is really a universal module transporter
board. I have about (4) fully assembled cards still in stock at $60.00
each (includes shipping in the USA).
They are fairly simple, but all the hard work is done for you!
I will try to get a page of pictures up quickly, and can provide any
number of these if you want to pre-order them.
(See, I read this list too! LOL!)
Best Wishes!
Cynthia