Hi all-
Since I've now switched over to a nice wonderful Stooge Cabinetworks walnut
cabinet, I'm putting my old, not-quite-so cool home-made cabinet up for
sale.
Basically-- 2 rows each a little bit longer than 20U. Made from Birch veneer
plywood and fairly clear pine. Forward and topward facing edges of the
plywood have been veneered. No back. Modules were attached with wood screws.
Not a tremendous beauty, but certainly a decent start! The face slopes back
at an angle of about 8 degrees. The end pieces have dado slots cut for the
cross-members, and the whole thing was screwed and glued. There are a couple
of slots cut in the upper support rail, for accommodating a prototype filter
module, and there's one arch-shaped cut out in the lower rail for
accommodating a larger-than-expected potentiometer body. Best if someone
picks up from Baltimore, but it's certainly shippable.
Pictures and almost the same text as above:
<
http://frank.gadgetland.net/modules.php?name=Sections&op=viewarticle&artid=49>
(watch the word-wrap), or go to:
http://frank.gadgetland.net/click the 'for sale' block (can't miss it, there's a big dollar sign there!)
and choose 'Wood Cabinet for MOTM - 20U by 2 rows'
Looking for $75.00 or sensible offer (not including shipping). Think the
price is terrible? Feel free to make an offer. No one wants it? That's
actually OK with me, as I can use the wood for something else... :-)
Frank-in-Baltimore