Hello,
I think the FS knobs on both edges could be nudged in just a little.
I hope Paul doesn't mind, but I uploaded a .jpg to the MOTM
yahoogroups files section showing from left to right: a MOTM-300, FS,
and a UEG. The file is called "300_FS_UEG_2.jpg".
http://tinyurl.com/u72f Also, I was playing around with adding lines to the FS panel to
visually group related functions. Not sure about them though..
Andrew
--- In motm@yahoogroups.com, "Tony Karavidas" <tony@e...> wrote:
>
> Someone brought up another issue privately and I wanted your thoughts as
> well.
>
> The UEG grid and the FS grid are the same
> See this photo
http://www.encoreelectronics.com/FS/FreqShift_Proto5.jpg for
> a pack of them together.
>
> Remember the right hand column on the FS is a little too far to the
right,
> but with that in mind, it was brought to my attention that the right FS
> column and the Left UEG column are probably too close for comfort if
they
> were mounted together like that.
>
> I see his point because the vertical spacing of the UEG knob columns
require
> the thumb and finger to be left and right of the knob (instead of
top and
> bottom or free flow around the knob) UEG knobs Rate3, Rate5, and
Rate7 would
> be hard to grab if the two modules are mounted next to each other.
>
> OTOH, I think it looks better this way, with the caveat of the
preceding
> paragraph.
>
> Here are my questions:
> Do you care or do you like that symmetry between the modules?
> If you like the symmetry, would a solution be to not mount the modules
> together.
> If I nudged in the left and right column of knobs on the FS, would that
> still look OK?
>
> A pack of replies would be great to receive quickly...I'm trying to
do this
> new board this weekend.
>
> Tony