> ----- Original Message -----
> From: osthelder <osthelder@...>
> I just finished my MOTM-ized BZ2300, the Blacet Binary Zone. I must say,
this is quite the toy!
I'm looking forward to building on myself. I'm still drilling panels for
everyone else right now.
> While drilling my Stooge panel, however, I failed to notice that the hole
marker labelled "clock" was really for an LED. I drilled it for an output
jack!
HA !! Don't think you are the first one to make that kind of mistake. One
of the things I do to avoid that when drilling Stooge panels is to drill all
holes the same size up to the point when each one quites getting drilled.
Once I get to 1/4", I cover the switches with tap. Once I get done with
5/16, I cover the LEDs with tape before I move onto the 3/8.
I ∗did∗ notice that the LED used the same buffer as the intended clock
outputs, so now I have two full-width clock pulse
outputs.
Good recovery. :)
Larry