Archive of the former Yahoo!Groups mailing list: MOTM
Subject: Kenton pro-2000 front jacks
From: "J. Larry Hendry" <jlarryh@...
Date: 1999-10-25
I ordered the Kenton pro2000 rack ears from Paul so I could get this thing
properly racked. Paul and I had discussed the idea of drilling these ears
to provide front panel 1/4" jacks. I did this and it works quite well. If
you put only 1/4 jacks, you can get six on each ear and use the same 7/8
wide spacing used on the MOTM modules. In the rack, they actually line up
right under the MOTM jacks. However, the up and down spacing has to be
reduced. I used 13/16 center to center.
Instead of 6 jacks on one side, I went for 4 plus a single MIDI jack. So,
I got the 2 channels of CV and gate and MIDI IN on one side and the 6 aux
voltages on the other side. I figure I wont need the other stuff on the
front panel.
Larry H