> From: "Dave Bradley" <daveb@...>
>
> 1. Need 12U, end buttable for a total of 24U (I misquoted my cab earlier,
> it's actually 24U). This takes care of top and bottom rails easily.
Ahh Moe.... I'm really disappointed to hear you may have made a mistake.
:)
> 2. Need some workable solution for a center rail in a 2 module high cab.
> Gaps between the rows are NOT acceptable cosmetically. This system is too
> nice to allow that. So we need rails with short sharp radius bends, that
> have the holes spaced back from the edge such that you can bolt the
module
> right to the edge of the rail. If the 12U rails mentioned in (1) above
> satisfy this criterion, then we can just use them bolted together back to
> back for the center rail.
It sure looks like they would work to me Moe. If you bolt the existing 19"
rails together, they leave no gap. So, as I understand it, we are talking
about exactly the same hardware except with the rack ears cut off and 12U
wide instead of 10U.
Stooge (I thought I had made a mistake once, but was wrong) Larry