Hello List!
I am also planning on mounting my PS on the rear of my case(s). My plans call for case(s) with 12-inch deep sides and, even though I plan to mount my modules 1/4" back from the face of the case(s), I figure this should give more than enough space.
The attached bitmap shows what my current system will look like when I find time to assemble my 410s. This is rack 1 of at least 3, maybe 4, that I hope to eventually build! Even though this diagram shows the PS in front, the finished racks will each have a Power Supply on the back .
I do have one question I would like to throw out to the list. Has there been any discussion about how you would group modules in the racks? For example, is it best to follow a left-to-right, VCO-to-VCF-to-VCA arrangement, or are there better ways to do this? Any input would be appreciated!
Thanks!
ChrispyCritter
Busted Flat in Baton Rouge
>>> "Paul Schreiber" <synth1@...> 10/18/99 01:23PM >>>
From: "Paul Schreiber" <
synth1@...>
I don't plan on any deep modules ∗except∗ the sequencer (and that's just a
definite maybe)
They are ~4 1/2" deep behind the panel. I would say allow at least 2 inches
from the rear of the
power supply to the rear of the modules.
Paul S.
-----Original Message-----
From: Tkacs, Ken <
Ken.Tkacs@...>
To: '
motm@onelist.com' <
motm@onelist.com>
Date: Monday, October 18, 1999 1:10 PM
Subject: RE: [motm] Dumb Power Supply Question?
>From: "Tkacs, Ken" <Ken.Tkacs@...>
>
>
>Cool, thanks for the info!
>
>15 inches deep-wow, that's a lot deeper than I was planning. I was thinking
>more like 8". Using the MOTM-300 VCO as a baseline, are there any other
>modules that are much 'deeper' than that? I don't want to make a case
that's
>too shallow and then have a module come out with a foot-long PCB on it.
>
>Unfortunately, space is of the essence in my studio, so I'd like to keep
the
>cabinets as shallow as possible.
>
>
>
> ^>^>^>This is exactly what I did, built a 20-space rack out
>of some nice-looking
> plywood, with 8 spaces of rails in the back, and mounted the
>900 in back.
> My rack is 15" deep, with the rails set in 1" on each side
>
>>