I don't plan on any deep modules ∗except∗ the sequencer (and that's just a
definite maybe)
They are ~4 1/2" deep behind the panel. I would say allow at least 2 inches
from the rear of the
power supply to the rear of the modules.
Paul S.
-----Original Message-----
From: Tkacs, Ken <
Ken.Tkacs@...>
To: '
motm@onelist.com' <
motm@onelist.com>
Date: Monday, October 18, 1999 1:10 PM
Subject: RE: [motm] Dumb Power Supply Question?
>From: "Tkacs, Ken" <Ken.Tkacs@...>
>
>
>Cool, thanks for the info!
>
>15 inches deep-wow, that's a lot deeper than I was planning. I was thinking
>more like 8". Using the MOTM-300 VCO as a baseline, are there any other
>modules that are much 'deeper' than that? I don't want to make a case
that's
>too shallow and then have a module come out with a foot-long PCB on it.
>
>Unfortunately, space is of the essence in my studio, so I'd like to keep
the
>cabinets as shallow as possible.
>
>
>
> ^>^>^>This is exactly what I did, built a 20-space rack out
>of some nice-looking
> plywood, with 8 spaces of rails in the back, and mounted the
>900 in back.
> My rack is 15" deep, with the rails set in 1" on each side
>
>>