>Use the no clean solder. Not all the user guides explicitly tell
>you to fill in the via holes but it's proper procedure to do it.
>I've actually gone back to a few modules I finished to fill them in
>which meant taking it apart to get at the back of the board.
OK :) I didn't know if "no clean" was safe.
>I don't know the answer to the 100pF caps. I'm confident that Paul
>has a good reason to not wash them.
I wonder what that is...
>As far as the caps, I think its because the leads are very thin and
>fragile and might break off when scrubbing.
I don't think it's that. I've been scrubbing the same set of teeth
with the same type of brush for over thirty years, and haven't broke
anything yet.