daveb@... writes:
>>Right now, everyone doing module dividers is rolling their own, using white
or colored tape. I use the 1/8" Chartpak art tape. We're trying to figure
out a better solution. I'd like to come up with some brushed aluminum
stripes that have small black tabs which fit under the module mounting
bolts.<<
elhardt@... writes:
This was one thing I though about too. I have some really thin white tape
(about 1/16" or so), but I figured it would eventually peel off. Perhaps
your tape recommendation is better. I also considered those rub on dry
transfers. But the pictures I have seen look like there is an actual 3D part
in there. They usually don't go all the way to the top and bottom of the
module either, I figured because the mounting rail got in the way. I will
look into your tape suggestion though.
Thanks,
-Elhardt