Welcome to the list!
Right now, everyone doing module dividers is rolling their own, using white
or colored tape. I use the 1/8" Chartpak art tape. We're trying to figure
out a better solution. I'd like to come up with some brushed aluminum
stripes that have small black tabs which fit under the module mounting
bolts.
Dave Bradley
Principal Software Engineer
Engineering Animation, Inc.
daveb@... > -----Original Message-----
> From: Elhardt@... [mailto:Elhardt@...]
> Sent: Sunday, October 17, 1999 3:56 PM
> To: motm@onelist.com
> Subject: [motm] Plastic Module Spacers?
>
>
> From: Elhardt@...
>
>
> I just purchased some MOTM modules and so I am new to this list.
> I figured
> when I get the modules, I would paint thin white vertical lines on either
> side of each module to get that Moog look and visual separation
> of modules.
> But then I noticed on a few old pictures it looked as if there
> was also some
> kind of white spacer or plastic filler that filled in the gap between
> modules. When going to the site of an MOTM user who built his
> own case, he
> used colored ones. Question is, what are they and where does one
> get them?
>
> -Elhardt
>
> >