Archive of the former Yahoo!Groups mailing list: MOTM

Hello All -

I'm assembling a Cyndustries module into an MOTM format Schaeffer US
panel. The module requires a 10K pot; I've found a Bourns panel-
mount pot, but it's 9mm. I assume this is OK with a little reaming
ala Oakley pots. Is this the right pot? Or are ther better
alternatives? Mouser part #652-3310Y-1-103.

Also, I need 3PDT switches; where can I get these in the same style
as the NKKs? I see DPDT on Dave's site, but no 3PDT.

Finally, can I use the 5mm LEDs at Mouser (645-550-1105 for red)?
Where do I get the cool little lenses ala MOTM for these?

Thanks mucho in advance.

Mike