The model number implies that this is a future MOTM module. If so this
is very interesting. A VC EG would give dynamic articulations to sound
parameters. Some of this can be done with a UEG or VC Lag processor,
but this module looks optimized for the task. Good luck on your
project.
John Loffink
jloffink@... > I'm finally into making hardware for this EG. I decided that the
best
> method of control of each parameter was to provide a dual-concentric
knob
> set for each. Front knob is 'initial' value, rear knob is reversing
input
> control of the external CV input. This way, things like assigning a
rate
> 'direction' and gain to applied CVs is is easy as it gets.
>
> I am putting two bicolor LEDs on: the cycle state LED and the
> oft-requested variable-brightness LED that follows the module output.
>
> And thanks to Larry (again):
>
> http://www.oldcrows.net/~oldcrow/synth/motm/m880pnl.jpg
>
> (I need to drill the 2nd LED's location, but this is the panel I'm
> working with for the 880 project).
>
> And for those curious as to where I'm getting dual-concentric pots:
1) I
> have several friends in Japan 2) Akihabara is a really cool place for
> (literally) spelunking for parts.
>
> Crow
> /∗∗/
>