NAMM cabinet has a full 1.5" in depth for jack clearance even on the bottom
slant row. It will be Stooge goal for this to clear OK. But, I cannot
promise. I can tell you I seriously doubt the same is true for dot com
cabinets because the angle is greater on the slant cabinet. Physically,
those cabinets cannot have 1.5" or the wood would be paper thin where cut
out for the jack clearance. I've played that angle and depth out to an
infinite detail to get the most possible depth clearance for jacks on the
NAMM cabinet.
Paul, will there be a 650 proto at NAMM to see if it will fit the bottom
row?
Larry
----- Original Message -----
From: Paul Schreiber <synth1@...>
Also, be aware that the jacks are on pc boards about 1.5" deep. If you have
a ∗slanted cabinet∗ in mind, chances are that these modules ∗will not fit∗
into the bottom cabinet row, because the jack pcb will collide with the
cabinet bottom. You will have to add about a 7/8" strip across the bottom to
allow the tilted boards clearance.