I've had success with these plugs by first filling the "cups" with solder,
then tinning the wire leads, then heating the solder filled "cups" and
inserting the tinned leads.
Hold the lead in place till the solder solidifies, and you should be good to
go.
Mark T
----- Original Message -----
From: <hodad1@...>
To: <motm@onelist.com>
Sent: Wednesday, September 22, 1999 3:17 PM
Subject: [motm] Neutrik plug help
> From: hodad1@...
>
> So I want to make some cords up for my MOTM. I have the cord, but I
needed
> the plugs.
> So I ordered up some Neutrik np2c plugs from Mouser, & they finally
arrived
> today (darn backorders!) So I open one up to check it out, & I can't
figure
> out how I'm supposed to solder
> the wires on as there are no little holes to poke the wires through.
> So i'm hoping someone who knows about these things will give me a little
> tip.
>
> tomr
>
> Oh, and yes I do feel a bit foolish about all this.
>
>
> >