>R15-17, TL071 (U1), and 3rd 33pF cap (C8) were supplied for the
inverter, so I popped them in there. Suppose it doesn't matter since
the in and out pads won't be connected?
Yes, this won't matter. That part of the circuit will be quite happy
just sitting there. If your TL071 is in a socket you could remove it to
save the excess 3mA it will draw.
>So I've already gone and soldered in Q2, D4, and R30-32.
If LK is fitted then Q2 must be removed. You can leave the other bits in
place but Q2 should be snipped out.
If everyone has my User Guide with these kits, then do not fit any parts
listed in the parts list that have been marked with an '∗'. Even if Todd
has supplied them. The '∗' marks optional parts and these are only
fitted if you are building the full 2U panel.
Hope this helps,
Tony