Archive of the former Yahoo!Groups mailing list: MOTM

once again i recently heard someone state that the motm modules were too
difficult to distiguish because of the lack of some sort of border
around each module. has anyone ever tried or considered polishing the
paint off the edges of your panels to make that border?

perhaps i will experement with a few diy motm panels i have (since they
are imperfect to begin with). taking just a bit off the corner so that
just a hairline of bare aluminum shows.

i know other methods of edging have been discussed, but i am not sure if
we ever considered paint removal?

sounds radical, but if done with care....

...jp