> From: JWBarlow@...
>
> 2) I was thinking of having a couple of metal strips manufactured
> which could
> be used as a buss/multiple system that would distribute the
> signal across the
> length of the rack rails (similar to Larry's suggestion a month
> or so back)
> -- has anyone tried this?
Paul will tell you that distributing audio signals on a buss is asking for
noise and crosstalk. Control voltage signals would be less sensitive - you
might think of distributing kbd and gate information. You still might need
to drive the signals with a simple op amp unity gain buffer.
> 3) If I don't do the buss thing, I might like to mount the middle
> two rack
> rails together so that there is no strip of wood separating the
> top row of
> modules from the bottom. Has anyone else done this? I've thought
> about using
> simple "L" brackets to mount the rails to the sides of the cabinet -- I'm
> hoping it would be strong enough(?)
Should work fine. I plan on having an angled front cabinet that is 26 units
wide and 10 units tall. The middle will be supported by 2 L shaped rails
fastened together either to form a T or a U (T is easier but I'm not sure if
the hole spacing between the 2 rows will allow for it). L brackets on the
end is what I was going to use, but not the flimsy ones you buy at the
hardware store. And avoid bolting them through from the outside - you don't
want a bolt head messing up that beautiful piece of hardwood you paid dearly
for, now do you?
BTW, folks should avoid aluminum for the rails - it's too soft to tap good
sharp threads into, and won't last if you move your modules around much. Use
iron or steel.
Dave Bradley
Principal Software Engineer
Engineering Animation, Inc.
daveb@...