I used the Moog design for a passive attenuator. Simple design, three
pots and 6 jacks. Wired so the first input will go to all 3 attenuators/
outputs. You disconnect the chain by plugging into the second
input/third input. So it can be a multiple as well. Very useful module
in my setup. Perhaps a 1U Stooge panel if Paul has no plans to release
such a module?
Terry
coyoteous wrote:
>
> What does one do for additional attenuation in the MOTM world? Most
> modules seem to have at least one input with no control and none (I
> think) have output controls. I prefer the convention with no output
> level controls and all input level controls (except v/8va inputs). I
> understand that this is a trade off between circuit functionality,
> panel real estate and module conventions - but, if this is truly a
> "modular" system - where is the attenuator module? There needs to be
> an alternative to burning a mixer (or half a mixer) to control an
> input. Also, is there a down side to passive attenuation? (no pun
> intended)
>