Not to proove just how dense I am, but how does this make sence? If you
input a tone with freq. content from 80Hz to 800Hz, and set the HP to
100Hz and the LP to 400Hz, then the BP out should give you 100-800Hz and
the LP out should give you 100-400Hz.
One of us hasn't had enough coffee, and it's probably me. Help?
--PBr
-----Original Message-----
From: The Old Crow [mailto:
oldcrow@...]
Sent: Monday, February 11, 2002 6:46 AM
To:
motm@yahoogroups.comSubject: Re: [motm] motm-480 cs-80 filter configuration?
THe input signals go into the first filter. The BP output jack is from
the FIRST filter. This output exists on the IG00156 filter chip as used
by CS machines, but is not used. The high-pass output of the first
filter
is hardwired to the input of the second filter. The LP jack is the
lowpass output of the SECOND filter. This is the stock CS configuration.
Input -> SVF1 (HP) -> SVF2 (LP) -> LP jack
|
(BP) -> BP jack