How about something hybrid? Use the rack ears for the 4 DIN jacks. Then
make a 1U Stooge panel with all the 1/4" stuff you want. Make use of
existing space. Takes up only 1U of module space.
Larry
----- Original Message -----
From: Alan Wagner
I’ve thought of this too. I like the idea of having all the Kenton outputs
right there in my MOTM rack. The down side is that it would take up 2U of
space that could be used for another module.
Larry has previously posted a picture that shows the Kenton outputs mounted
on the rack ears to bring them to the front. This idea makes use of existing
space.
I haven’t done either one yet because frankly I’m undecided on which way I
want to go. I am leaning toward the rack ear idea for two reasons. First
space is a premium in my setup. Second I didn’t want to purchase $$$ a blank
panel for this because my homebrew panel graphics suck so it would not
compliment my MOTM modules.
However, if someone were to do a panel run I could be persuaded to go the
breakout panel route!
Another $0.02
Tx
Al
Yahoo! Groups Sponsor
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.