Hi Guys,
I am about to wire up my Oakley wavefolder and the NON-Motm instructions
have left me with a question. How many Sheilded wires did anyone who built
one of these use. Did you use sheilded for all wires?
On the PCB there are 2 pads for wiring connections, 1 Square 1 Round. I
assume the square one is the pin one like IC's or the hot wire for the CV
connections?
To normalize the CV inputs to ground there is a pad on each CV input. Now I
could wire the top lug of each switchcraft to here right to normalize the CV
to ground. OR I could put a resistor lead clipping to the beveled lug which
will be connected to the board ground "Jack to Jack" like the back of a
multiple module. Which is the best way to short CV ins to ground?
For the Soft out, Clamp Out and Clip Out there is only one wire connection.
Do these need sheilded wires? There is one hole for use by all three of
these outputs that could serve as my ground here if needed.
Please Help, I only want to maintain the star grounding and MOTM standards
with each of these non-motm modules. Paul, your instructions RULE!
Thomas White
_________________________________________________________________
MSN Photos is the easiest way to share and print your photos:
http://photos.msn.com/support/worldwide.aspx