OK, so this is from a mediocre builder, but I have built nearly 30
modules (including Blacet stuff). Use a tie for all coax, but you
don't have to lay the cable flat: let it do what it wants. The tie
acts as a very effective strain relief. Just make sure the cable
isn't scraping too much against sharp edges.
Mike
--- In motm@y..., "gooboworks" <andy@g...> wrote:
> Since Paul is busy with NAMM, I will post this question here.
> Assembling the 101 Noise S&H, on page 10 a coax cable is soldered
> into the CLOCK pads at J5. The instructions do not say to lay the
> cable flat and secure with a tie wrap, however there are tie wrap
> holes on the PCB and spare tie wraps came with the kit. Do I lay
> this coax wire flat on the PCB and tie wrap it down to the board,
or
> does the wire come straight up from the connection?
>
> Thanks
> Andy Miller