Oh, ah!
Very nice photo set indeed.
The comments about keeping the wiring under control are well taken. I
attempted to use ribbon cable bits to keep from getting the 'beard of wires'
effect. It turned out still looking a bit on the messy side even so, though
not as bad as it would've been had I used separate wires for everything.
Hmmm. I also ended up making up a little daughter board for the leds, out of
a section of Radio Shack prototype PC board, with 2 sets of eight wire
ribbon cable bits running to each of the bank and wave groups of leds.
After engineering the fitting of the MW module to the Stooge panel, I
realized how easy we really do have it with Paul's kits- down to the
pre-tinned bits of co-ax all cut to length...!
I've really quite enjoyed using the finished module, BTW, though I feel as
though I haven't really yet scratched the surface...
Happy Nooo Year!
Frank
Baltimore
-----Original Message-----
From: J. Larry Hendry [mailto:
jlarryh@...]
Sent: Monday, December 31, 2001 9:14 PM
To: MOTM List
Subject: [motm] MOTM version Miniwave photos
... for those who care to check
out the photos, here they are:
http://www.wiseguysynth.com/larry/mw2090/2090_construction.htm