Hello David,
There are no instructions with the Stooge panels. I assume you are
building the MOTM style kit from Blacet? You can wire the jack grounds the
same as the sketch in the Blacet manual. The ground wire does not need to
be bare buss wire, you can wire jack to jack if you like.
The now off board pots wire to the PCB in the same fashion as the on board
pots would be. If you look at the PCB there are 5 solder pads for each
pot. For the MOTMized version, the larger of the five holes are not
used. The pot shell that would normal be supplied with the normal Blacet
kit attaches there. One of the inner 3 smaller pads is marked as pin 1
with a numeral 1. The pad attaches to terminal 1 one the off board
pot. The pad beneath the # 1 attaches to terminal 2 on the pot and the 3rd
pad attaches to terminal 3.
If you need any more info, you can email me directly if you want, and I can
send you a pic, or small schematic of what you need to do.
dave
At 02:38 AM 11/30/2001 +0000, you wrote:
>Hi everyone,
>
>I'm building an MOTM-ized Dark Star, and I need suggestions on
>redoing the jack and pot wiring for the Stooge panel I've ordered.
>The Blacet instructions call for the jacks to be all wired together
>to a common bare ground wire, and I think changes will be
>needed for the pots as well. Does anyone know of a
>resource/summary of the wiring changes for this module? Other
>sources of help?
>
>There may be instructions to this effect included with the Stooge
>panel, but since I don't have it yet I'm not sure.
>
>Thanks in advance!
>
>David
>
>
>
>
>
>Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/