Archive of the former Yahoo!Groups mailing list: MOTM

These questions came privately, but I think they are of general interest to
any 850 owner, so.....

A loyal MOTM customer wrote:
Will you probably offer the pcb/parts for the upgrade ?

Stooge Larry responds:
Well, I could if there was enough interest. BUT, the PCBs are off the shelf
for under $2. It has one op amp (you can pick from several - I am using the
same one as in the 850, and 822 and 831) 4 resistors, 2 caps and one jack.
The whole thing should cost you about $5.

A loyal MOTM customer wrote:
Also will this turn the 850 into a BC module only or will it function as
both?

Stooge Larry responds:
It will not change the 850 function at all. If you plug the breath
controller in, it is a breath controller, if you don't it is still a pedal
interface. I am planning to install the correct sized jack on my panel for
the breath controller to plug directly in. However, I hate those small
jacks.

Larry