At 9:36 AM -0700 10/17/01, Tony Karavidas wrote:
>
>I looked on Larry's site and didn't find it, but Mark's email did
>the trick.
Well, it's not a mod anyway. For all intents and purposes it's a separate
module. It will generate triggers from any stepped voltage.
>Anyway, I was thinking there might be a decent way to use the
>Step/Finish/Release switch to allow the trigger output to fire a pulse for
>every step, or for the end only like it currently is implemented. I didn't
>like the hidden panel feature, but it almost would be documented on the
>face.
That's a good point. Besides having a feature hidden is better than not
having it at all.
>In LoopOnly mode, the Step/Finish/Release switch doesn't currently do
>anything, so I could make the Release position active to trigger upon
>release, and make the Step position active to trigger at every step.
Would you believe that I had the same exact idea??
>What do you UEG owners think?
I think it's a great idea since Loop never reaches stage 8. If you want to
give all four jacks a function in Loop mode how about this:
Step -- loop runs continuously, trigger on each stage
Finish -- new loop begins only if gate input is high, trigger on each stage
Release -- loop runs continuously, trigger only on last stage of loop
>I can't do this for a while, but if you think it's a good idea, you might
>be able to hold off building that extra circuit.
How would this work?? Would you mail out a ROM upgrade chip??