> >Paul has thoughtfully made his
> >instructions so that when you take inventory at the start, each part is
> >listed in the order it's used in the construction (with very few
> >exceptions) so if you stuff each part in order into a foam block, you'll
be
> >able to pick it out in order during construction. (Good job, Paul!
Even
> >Heathkit didn't do this.)
> >
> Gee, ∗somebody∗ finally noticed! :)
>
> Paul S.
OK, here I must publically admit that I change the order ot parts added to
the circuit board. In general, I add parts according to height (OK, call
me a fool). I find it a lot easier to solder the chips completely flat on
the circuit board if I skip the tall capacitors until after I get the chips
on.
Larry H.