Tony -
I read this with interest on the Oakley list. Forgive the silly
questions but I want to make sure I understand. The CV and Gate
connectors would allow me to 'pre-patch' CV and gate signals in a
routing that I would normally use. But by patching using the jacks I
could override the 'pre-patch' Correct?
Also, I use a mult to distribute CV and Gate currently. Would this
board offer the ability to 'pre-patch' multiple CVs and Gates?
Thanks!
Mike
--- In motm@y..., "Tony Allgood" <oakley@t...> wrote:
> >You are all confused.
>
> Me too...list crossover. Yikes.
>
> >The original post talked about .156 connectors (MOTM and Oakley
> standard for POWER connections, and additional .100 connectors for
> bussing KBD and GATE signals.
>
> Actually, I just checked and I didn't say it directly, just sort of
> inferred it. But you are quite correct. The power bus would of
course be
> 0.156" connectors. The CV and gate would be 3-way 0.1" types, small
> enough to be ignored if not wanted.
>
>
> Cheers,
>
> Tony