> I'd suggest this as a possible mounting strategy for the Blacet
> version also. Cut up a generic pcb from Rat Shack to physically hold
> the LEDs together, then mount the whole thing with RTV. That's the
> approach I'll probably take - including using the ribbon cable to cut
> down on wiring clutter.
as if by magic, my farnell order arrived this morning...
hello all,
what a great idea - a bit of stripboard to keep all the LEDs in check
i found a set of 4mm cylindrical LEDs which at the moment don't fit in my
oversized holes - so i plan to make them fit by carefully (this time) filing
out the panel until i can jam each LED in, in this case i should need any
glue and the piece of stripboard should stop any individual LEDs from coming
loose
i suppose if you were that way inclined you could use an oversized piece of
stripboard and put a small bolt through the panel (cue stooge scream)
cheers
paul b