On Thursday, August 30, 2001 9:48 PM Paul Schreiber <
synth1@...>
wrote:
> Now that Larry is hard at work (cough cough) on the pedal interface, I'm
> focusing on the MOTM-310 MicroVCO.
Seems like a lot of coughing going on over there. Everything ok??
> The only other possibility is: the 4th pots is a 'blend'. The VCO has 1
OUT.
> The 4th jack is PWM IN. With no plug inserted, the PULSE is 50%.
> Else, the input is a -5V to +5V pulse width control (no input
attenuation).
> So you can get SAW to PULSE with the blend. This is not as gnarly as
> the TRI stuff, and possibly more musically useful.
>
> Well??!?!?
I very much like the concept of manipulating the waveform with CV, so I'd go
for the blend pot and the PWM IN jack. Definitely more musically useful,
IMO. Very slick, the normalled PWM jack! So, if I set the blend to SAW,
what effect does the PWM CV have? Does it change from saw-up to tri to
saw-down?
Hey, could there possibly be an on board jumper to change the PWM IN jack
between PWM and BLEND? (I guess there's no room for a switch. Bah!)
George