tjhanx for the suggestion, i'll give it a try tonight, i know theres a mix
control on the back of the amps for the loop, i'm just hoping it's a post
fader vs. a pre-fader. my other concern would be the way the amps are daisy
chained (slave out to power amp in) hopefully this will be a global control
and limit the levels on all amps, not just the one i'm plugged into. thanks
to everyone for all the help/suggestions. -nate
>
>Um, I might have sent this to Nathan already, but my former ISP
>
>dumped me, so if I did and he replied, I didn't get a message.
>
>
>
>Wouldn't it be easiest just to plug into the FX loop returns of the
>
>Mesa 400+ amps? Those are already set for line levels, and (I'm not
>
>sure about the 400+) most of the Mesa amps I've seen even have an
>
>input attenuator at the FX return in case the MOTM output is still
>
>too hot.
>
>
>
> -Doug
>
>
>
>--- In motm@y..., Nathan Alan Hunsicker <nate@e...> wrote:
>
>> is there any quick way to get motm levels down to instrument
>
>levels? i'm
>
>> playing with a guy next week who wants me to run through 4 mesa 400+
>
>> bass amps, i want to make sure i'm not going to blow the preamps
>
>out on
>
>> his amps and i don't feel like lugging my PA over either. I don't
>
>have
>
>> the mixer yet and my smallest mixing board is 36 channels (it
>
>doesn't
>
>> travel all that well) would tying a resistor between hot and ground
>
>on
>
>> the final output do any damage to my modules? let me know if anyone
>
>has
>
>> any ideas. -nate
>
>
>
>
> Yahoo! Groups Sponsor
><http://rd.yahoo.com/M=190462.1393721.2979173.2/D=egroupmail/S=1700032277:N/A=55
>1015/?http://www.debticated.com>
> Your use of Yahoo! Groups is subject to the
><http://docs.yahoo.com/info/terms/>Yahoo! Terms of Service.
Please reply to:
nate@...www.etanstudios.com