Archive of the former Yahoo!Groups mailing list: MOTM

Sorry to go off topic, but the 'tron knowledge in this group must be
tapped to find a strange item. If you don't care about interconnects
or such stuff.... DONT READ IT!

Ok, I am trying to repair a very strange piece of synth. It would
seem that it is possible to repair it, but to correct a design defect
the best thing might be to employ a ribbon cable to connect 2 pairs of
DIP sockets, both wide bodies (.600) one being 24 pins the other 40.
So far I have only been able to find 3M that make ribbon cables with
DIP connector sockets on the end. That would be fine but no one seems
to have them.

Any suggestions on where to look? Other manufactures?

Thanks a bunch, sorry for the off topic.

Bruce