>
> Thank you, I found similar information in the books I checked, but I was
> unsure how much depended on the impedances involved. As you know, modern
> line level inputs are rarely 600 ohm, and I didn't want to use an equation
> taken out of context.
If it's not 600 ohms, the 0.77blah blah blah number changes. The new number
is left as an excercise for the reader.
>
> This is where I get confused. Your earlier statement that, "the signal
> generators in MOTM use 10V pk-pk, or around +22dBu" seemed more in line
> with what some of the other people on the list are saying.
>
> For example, Larry seems to be using a Mackie, and Mackie claims a MIL of
> +22dBu, yet:
>
>
> So how is +13dBu anywhere near the edge of being too hot?? This doesn't
> make sense to me. I'm trying to contradict anyone's observations, it's
> just that I think I must be missing something.
Well, +13 is lower than +22 :) Mixers have either an input pad trimmer or a
knob to adjust
this. So, shouldn't be an issue coming to going.
>
> Also, when I enter 20 ∗ log (10/.7746) into my calculator I get 22.22.
> Working the other way, (.7746) ∗ 10^(22/20) = 9.75. Would someone please
> double check that for me?? If humanity relied on my half-assed math
skills
> we'd still be living in caves :)
That's because the .7746 is ∗RMS∗. When you plug '10' into the equation,
that
means 10Vrms or 28V pk-pk. That is where the +22 comes from.
Again, just buy a mixer that has attenuators on the insert bus.
Paul S.