Archive of the former Yahoo!Groups mailing list: MOTM
Subject: Re: [motm] how hot is enough??
From: "J. Larry Hendry" <jlarryh@...>
Date: 2001-03-26
----- Original Message -----
From: <mark@...>
According to Mackie, their aux sends are +22dBu.
---LH---
I too have found using aux sends gets one real close to where they might
want to be at the input of a MOTM module. Ihave also used headphone outs on
a mixer for the same purpose.
>For output, I run the final 110 VCA output into a channel on my
>Mackie. You have to watch the CV gain on
>the 110, you can overload the preamp on the Mackie easily, but once it's in
>range, it's not a problem.
The maximum input level is +22dBu as well, according to Mackie.
---LH---
I have found MOTM levels to be right of the edge of being too hot into a
mixer like this. Of couse, for a MOTM output going to a mixer, if would be
simple enough to just divide the voltage coming out of the MOTM with a
couple of resistors priot to going into the mixer.
Larry H