Archive of the former Yahoo!Groups mailing list: MOTM

I had to try it, it only works really subtly, kinda what I had expected..
just barely noticeable.. it does change up the shape nicely though as It
should (DUH) Will the MOTM phaseshifter work on CV's as well? As in, input
a triangle LFO and out comes the same but phaseshifted 90 or 180 degrees? Am
I retarted? NEW ! MOTM 340 Quad phase LFO. selectable Sine/saw, four
different phase outputs..
anyway.. I stumbled into the 'ol 300-->MOTM 120 (only #3 full on) gating an
800 (for shapecontrol), 800+ output ---> LFO FM input. makes a nice
stairstepping CV when tuned right.. a bit touchy but nice when you get it
where you want it..
add raw LFO outs and LFO run through 820 outs to a few key places and space
out..later,
~Steve
(now if we had VC panning!!!!)