Archive of the former Yahoo!Groups mailing list: Vintage Simmons Drums (UK) Users Group

previous by date index next by date
previous in topic topic list next in topic

Subject: Re: [Simmons Drums] sequence the SDS-V

From: Thomas Heckmann <troperecordings@...>
Date: 2015-09-18

Hi,

there is a dedicated SDS V sequencer that is the SDS-6 ;-) It has dynamic trigger programming (7 steps as far as I remember).

Also I’m using a couple of the Elby Designs / Ken Stone Midi 2SDS(X) modules for the Eurorack.
You can play them dynamic over Midi and it has 8 programmable outputs.

Works fine with all the drum synths that I have and the SDS.

There’s also the Tama TSQ-1000 trigger sequencer, but it’s quite hard to find.

Best,

Thomas

Thomas P. Heckmann
troperecordings - afu limited - afulab - trope mastering

On 18 Sep 2015, at 00:05, nuipb1@... [Simmons_Drums] <Simmons_Drums@yahoogroups.com> wrote:

Hi Group,


Is there any such thing as an adequate sequencer for the SDS-V other than the MTM ?

Ideally one that you could record with from pads and that would record the triggers of course, but also velocity and that could be clocked externally.


I found this idea here:

Simmons SDSV with MFB SEQ-01

but as far as I know the MFB SEQ-1 supplies only Accent (that is 2 levels of voltages) not all the voltage range between 0V & 1,5V (1,5V being the maximum voltage via the Pads inputs right ?)


I also heard about connecting each SDS module input to a separate output of a Roland TR-707 for example, but I believe the TR-707 has only accents too (I'll have to check on that), so no velocity.


So what nice solution did you guys find for this job ?


Phil