I would be interested in 2 pieces also, depending on price.
WT
----- Original Message -----
From: "Thomas Heckmann" <troperecordings@...>
To: <Simmons_Drums@yahoogroups.com>
Sent: Sunday, July 07, 2013 11:20 AM
Subject: Re: [Simmons Drums] Re: SDS 6/7 Mem Cart - need dimension info
> Hi,
> I would definitely take two of your cards, one for my SDS-6 and one for my
> SDS-7. Probably a third one, but it
> also really depends on the price. Do you have something in mind concerning
> the price ?
> And I'm sure a lot of people would want to have one on this group as well
> :-)
> Best,
> Thomas
>
> On Jul 7, 2013, at 11:13 AM, Richard wrote:
>
>> Just uploaded 5 pics of the 3d rendering of an alternate version of the
>> memory cart. It still uses old school "through hole" components as each
>> one would be hand built to order. If interest was strong enough for a
>> "standard" 4k memory cart, I would do them PCB's as surface mount and get
>> a batch of them made in china or similar (to keep cost down) then fit
>> them into cases. If this path was taken I'd have to order a minimum of
>> around 50 units.
>>
>> As stated previously,my ultimate aim is to produce a unit that connects
>> to the cart port on an SDS 6/7 that emulates the RAM connections. This
>> would be done via a microcontroller or FPGA that would include an SDCARD
>> and or USB connectivity. The unit would have an LCD display and a few
>> buttons and connect to the cart port via a cable. Having USB would allow
>> for software on a PC that would allow "offline" editing of stored
>> parameters and data for the SDS 6/7. Don't hold your breath as this would
>> be a more complex job for a unit of this kind.
>>
>> In the interim, the current cart set up would suffice, though I am
>> looking at a "multi cart" base board.
>>
>> How much interest is there in all this? How many of you would be after
>> carts? I'm going to try and keep the cost as low as possible so the
>> numbers interested in a cart or 2 needs to be at least estimated.
>>
>>
>>
>> --- In Simmons_Drums@yahoogroups.com, "Richard" <warlandr63@...> wrote:
>>>
>>> Work is progressing on a cart clone in various forms. I need to know
>>> what the overall outside dimensions are of an original cartridge. My
>>> reason for this is that in the process of developing a new cart, it has
>>> come to mind that I could also design a baseboard that plugs into the
>>> SDS 6/7 cart port that allows you to fit say 4 to 8 carts and select the
>>> one to use. This would be great for existing cart owners and also allow
>>> "mass" storage until I can design a new cart that allows USB and SDCARD
>>> storage. (this unit is more work that in looks, it needs an lcd display,
>>> keypad etc and would be a stadn alone device that plugs into the cart
>>> port via a ribbon cable)
>>>
>>> If some one can supply the cart dimensions I will know how far a
>>> distance between sockets I would need for the multi cart base board
>>>
>>
>>
>>
>>
>> ------------------------------------
>>
>> Yahoo! Groups Links
>>
>>
>>
>
> Thomas P. Heckmann
> troperecordings - afu limited - afulab - trope mastering
>
>
>
>
>
>
> ------------------------------------
>
> Yahoo! Groups Links
>
>
>