Speaking of velocity control and Trig Out... A bit off-topic perhaps, but what's the recommended setting for driving the SDS-V with an MTM? Should the trig output be set to +15V or less... and it seems like the SDS-V sensitivity should be set to "Minimum" (turn sens knobs to the left) to minimize cross-triggering... or ?
cheers
// Lars
--- In Simmons_Drums@yahoogroups.com, jesper <jesper@...> wrote:
>
> Mark Frost skrev 2011-12-13 23:36:
> > Well the best of luck to you Brian - most of that would be beyond my
> > capabilities. As amatter of interest, is it practical to use 2 MTMs (I
> > gather Jesper has 3)Is that a 16 pad setup? Merely interested, as I had
> > to incorporate a roland octopad to keep things within reach
>
> I only use one for pads to midi and all three for midi to drum synths.
> The good things with the MTM is the velocity control and that you can
> choose the output voltage. Now one controls my SDS-V, one the SDS-7 and
> one the SDS-III, SDS-IV and Pearl Syncussion. The inputs range from +5
> to +15 volts and therefor I find the MTM so good. Many trigger devices
> are more or less stuck at +5 or sometimes +10 while the MTM can deliver
> all the way to +15.
> Also, many trigger devices have locked midi note numbers. With this
> setup I can have all three MTM's on the same channel and the trigger
> spread across the master keyboard.
>
> --
> electronically yours, jesper
>
> - -- --- ---- ----- ---- --- -- -
> www.electronic-obsession.se
>