Roland,
Nice to talk to you! That would be amazing if you could make a pair up for me!
Let me know how much you'd want and I could paypal it to you. Would it be
possible for you to fabricate it in a metal similar to the stainless aluminum
look of the SDSV panels? Let me know and thank you so much for responding!
-chris
________________________________
From: Roland <
rolandbrenner@...>
To:
Simmons_Drums@yahoogroups.comSent: Sun, April 17, 2011 11:01:56 AM
Subject: [Simmons Drums] Re: SIMMONS SDSV Rack Ears?
A trip to the hardware store for some aluminum angle iron is the simplest. All
you need is a drill and some screws after that. Since the V is shallow and
relatively light weight ( as compared to stuff like amps ), you won't need to
support the back end either. If that's not possible for you, let me know and
I'll make up a set for you ( I have plenty of stock ).
GOOD LUCK !!
- Roland
--- In Simmons_Drums@yahoogroups.com, "chris" <mimountains@...> wrote:
>
> I have an original Simmons SDSV brain with the standard metal case. When I
>took it apart to do some repairs I noticed that there were some pre-drilled
>holes on the sides of the interior casing. Upon further research I found that a
>few people had mounted their units in racks using rack ears. My outer casing is
>pretty banged up and I'd really like to rack mount the SDSV. Does anyone have
>any suggestions on where to get a rack kit for the SDSV? Was there one made by
>Simmons? Does anyone have a kit that they'd sell me? Please let me know
>
[Non-text portions of this message have been removed]