Berk Aarts skrev:
> this is not about the pads, this is inside the module!
I know, and I just cut them close to the soldering joint. It sure
helped! When racked you see the inside from the top of the unit since
the cover is removed. I climbed in behind my massive rack and removed
the back panel screws to get room for the cutter.
> Seems the pinning on the XLR is wrong, maybe this is also giving less output
> since you use a patchbay??
No, it was the resistors pulling the signal down. My wiring is correct
and has worked for years... Simmons was british, hence everything is a
bit "exotic". The way we all like it! :)
--
electronically yours, jesper
- -- --- ---- ----- ---- --- -- -
www.electronic-obsession.se