Hi There
The service manual for the SDSV mentions that you should not fit the cymbal or hi hat modules into the channel one position as the 5volt regulator on the piggy back board could short out on the cheek of the chassis.
Regards
--
Darren
-----Original Message-----
From:
Simmons_Drums@yahoogroups.com on behalf of jesper
Sent: Thu 22/01/2009 5:48 PM
To:
Simmons_Drums@yahoogroups.comSubject: Re: [Simmons Drums] SDSV Module Positions
monzarottie skrev:
>
>
>
> Hi all. I just received my SDSV Cymbal and Hi Hat modules today (along
> with a cymbal pad and Hi Hat pedal). Woohoo! [:D]
>
> Does it matter which slot the Cymbal and Hi Hat modules populate? I
> don't want to blow anything up.
Congrat's and welcome in the club! (though I miss pedal and pad)
No there's no need for a special slot as long as there is room for
everything. The proms might make the cards slightly thicker than usual.
I have my cards in slot 6 and 7...
--
electronically yours, jesper
- -- --- ---- ----- ---- --- -- -
www.electronic-obsession.se
www.myspace.com/machinepop
- -- --- ---- ----- ---- --- -- -
"Spotify is fully legal and so should our content be too."
[Non-text portions of this message have been removed]