hauke11de skrev:
> I tried to trigger my SDS-5 from a RX-5 Drumcomputer by Yamaha, using
> single outpost from the RX-5. unfortunately I am not satisfied with
> the result as I can't manage to have a proper trigger-signal. Whenever
> a module of the SDS-5 is "hit" by a signal all I get is a very low
> sound with only little loudness/velocity. I also tried it with an old
> Casio FZ10M sampler... same result. No sounds at full velocity from
> the SDS-5.
>
> What inputs at the SDS-5 should I use?
With sound - use the pads inputs (XLR) but do measure the levels put out
by your trigger unit first. I think they handle up to 1,5 but I'm not
sure. I have to double check the manual for that.
The "synth input" reaches it's maximum at 7 volts and can take up to 10.
I trigger mine with +5 (still not having finished the mod to my
midi2sds2 - bad) and it works great except for the snare card which
never get that rimshot effect the manual describes. You're supposed to
hit it with full force to get the "clack" in the sound.
--
electronically yours, jesper
- -- --- ---- ----- ---- --- -- -
www.electronic-obsession.se
www.myspace.com/machinepop
- -- --- ---- ----- ---- --- -- -