Hello,
the selector pad is only 16 switches, arranged in a matrix with 4 inputs and 4 outputs. These have always to be isolated. In your case, something must shortcut one or more of them to ground potential, disturbing the I/O section of the CPU. This might be: A bad jack, a bad cable or- a contact made when the selector jack is inserted into the socket. Several easy tests first: Try to insert the selector jack only half. Remove the selector jacks housing and plug it in without it. Examine your cable, if there is something hurt. While inserted, shake your selector cable near its jack and near the point, where it goes into the housing. What happens? Then: Check, if there is a connection/ shortcut between the ground wire and one of the 8 data wires in the jack. If so, search, where this happens.
I hope, this helps.
Michael
----- Original Message -----
From: Haley Johnson
To: Simmons_Drums@yahoogroups.com
Sent: Thursday, March 06, 2008 1:24 PM
Subject: Re: [Simmons Drums] Selecter Pad for the SDS7
Hi All,
I would just like to say that Roger Davis is one COOL customer!!! I fell so bad about the SDS7 brain that I sold to him on e-bay. I was REAL worried that something would go wrong with it because it made a trip across the USA. EAST to WEST. I hope that someone out there can help with the problem with the selecter pad. It sure would be great if it worked right. Hats off to you Roger and know that I will help you out with this to the END!!!
Haley J.
monzarottie <roger.davis@...> wrote:
--- In Simmons_Drums@yahoogroups.com, jesper <jesper@...> wrote:
>
> crew38special skrev:
> >
> >
> > Hi all,
> > I just sold my backup SDS7 brain and selector pad to someone on E-
> > bay. The brain and selecter pad all worked fine before I sent it.
Now
> > he said that when he powered it up that there was no display read
out
> > and the selecter appear to switch kits but no display and a decay
seems
> > to be set on all sounds. "CRAP"!!! He said that he moved the
program
> > module in it and that cleared that up BUT the selecter pad when
it is
> > plugged in the display go's away. "CRAPPPPPPP"!!!!!!!
> > You guys tell me but I think that it is in the program module or
> > maybe the battery module.
> > If someone can help with this that would be sweet. I'm not sure
> > what to say other than Welcome to VINTAGE GEAR!
> > Haley Johnson
>
> I hope you sold it without guarantee 'cause shipping a SDS-7 is
always
> risky... The selector pads sends some kind of digital message -
right?
> If so, a loose wire can result in all kinds of weirdness.
>
> I hope you guys agree on a decent solution.
>
> --
> electronically yours, jesper
> - -- --- ---- ----- ---- --- -- -
> www.electronic-obsession.se
> www.myspace.com/machinepop
> - -- --- ---- ----- ---- --- -- -
>
Hi there,
I'm the buyer and certainly hold no grudges. The brain works fine.
Only the display goes out when the selector pad is connected. I'm
not too worried about it, but it would be cool to figure it out.
I'll look a little closer at the multi-pin connectors when I get a
chance. Overall it's a great piece.
Roger
---------------------------------
Be a better friend, newshound, and know-it-all with Yahoo! Mobile. Try it now.
[Non-text portions of this message have been removed]
[Non-text portions of this message have been removed]