Sorry for the long delay, i was busy and didn't take the time to come
and see if i had answers.
Thanks for your response (waveterm_b and mkirmuc).
Well, here are the details:
When i plug an MTM trigger output (any channel) to an SDS-8 pad
input, the SDS-8 input triggers constantly (sounds like a train). And
this, even if i lower the MTM trigger output level all the way to
zero. The only way i can stop this is by lowering the SDS-8
sensitivity for the channel until the self-triggering stops. I have
to compensate by tweeking certain parameters in the MTM but i cannot
get exactly the same sensitivity i can normally get when using the
SDS-8 alone.
The only thing i can think of is that there may be a DC offset
voltage at the MTM's trigger outputs. Or maybe there's something
wrong with my SDS-8?
Any other ideas?
I would like to know if someone else ever experienced this behavior
when using these two devices together.
And curiously, i do not have this behavior when trying the MTM with
an SDS-9. It works very well.
Thanks,
Norm.
--- In
Simmons_Drums@yahoogroups.com, Michal Kirmuc <mkirmuc@...>
wrote:
>
> I use MTM with SDSV, SDS7 and SDS8. Can I help you?
>
> Michal K.
>
> WT <waveterm@...> wrote:
> What´s your problem ?
>
> WT - Know a bit or three about the MTM
>
> http://medlem.spray.se/waveterm/LJLab2006/
>
> ----- Ursprungligt meddelande -----
> Från: "norm2600" <norm2600@...>
> Till: <Simmons_Drums@yahoogroups.com>
> Skickat: den 20 april 2007 16:30
> Ämne: [Simmons Drums] MTM and SDS-8
>
> Does anyone here use an MTM with an SDS-8?
> I would like to compare and discuss certain behaviors i have with
this
> setup.
>
> Thanks,
> Norm.
>
>
>
>
>
>
> ---------------------------------
> Ahhh...imagining that irresistible "new car" smell?
> Check outnew cars at Yahoo! Autos.
>
> [Non-text portions of this message have been removed]
>