Adam Adamowicz
Serdecznie witam wszystkich drumerow bebniarzy!
Perkusja Simmonsa to moje zycie choc u nas w Polsce o taki sprzet trudno ja musialem sie zadowolic jego polskim odpowiednikiem z firmy Polmuz z Warszawy. Pomimo postepowi techniki w elektronice muzycznej perkusja Simmonsa zawsze pozostanie moim legendarnym zestawem. A tak przy okazji wysylam Wam moja fotke. Przepraszam ze nie znam angielskiego.
-- wiadomość oryg. --
Temat:Re: [Simmons Drums] SDS7 Part(s) needed!
Od:"Gordon JC Pearce" <
gordon@...>
Data:08 marzec 2006 00:26:27
Rodney wrote:
> Hello all!
>
> Several months back, someone responded to my query about a replacement
> for the DATA PANEL for the SDS7, and I wasn't able to scrape up the
> money for it...since then, I have lost his email address, and now I
> have the money for it (Isn't that always the case???)!!!
>
> I am looking for the whole DATA PANEL for the SDS7, with all the
> buttons & the BIG knob & display(intact, of course)...don't really
> need the internal connecting cables(s), but probably wouldn't hurt ;)
>
> I bought an SDS7, but the damn BIG knob is broken off of it, sheared
> at the base of the knob, so I can't even turn it with pliers or
> "other" tools...works perfectly other than that (and I'd rather not
> try to replace the knob with an aftermarket "guesstimation")!
I had a new spindle made up from brass rod by one of the techs at the
college I was at, a good few years ago. Before I did that, I used a
long bolt and a bit of brass tubing as a bush.
Unless the electronics on the control panel is damaged, you wouldn't
need the whole thing. Have you got the opto disc? If not, you could
easily make one out of thin plastic sheet.
Gordon.
Yahoo! Groups Links
[Non-text portions of this message have been removed]