I believe Pearl had 8 sided pads. Check it out-
http://www.tcgakki.com/ smashfolder/DATA/03/DSCN9906.jpg
If I recall correctly, Simmons pads will fit on Pearl hardware, the
tom arms are the same diameter.
Jeff
On Jan 7, 2006, at 9:02 AM, Simmons_Drums@yahoogroups.com wrote:
> There is 1 message in this issue.
>
> Topics in this digest:
>
> 1. Re: Simmons Drum Pads Stand?
> From: <jesper@...>
>
>
> ______________________________________________________________________
> __
> ______________________________________________________________________
> __
>
> Message: 1
> Date: Sat, 7 Jan 2006 11:15:27 +0100
> From: <jesper@...>
> Subject: Re: Simmons Drum Pads Stand?
>
>>>> Wasn't it "UP" that did octagons? Dynacord was pentagons if I
>>>> remember
>>>> correctly...
>
> steve:
>> uP used an uneven six sided pad at one time - like a triange with the
>> corners
>> cut off.
>
> That's it!
>
>>> Something dusty gate in the depths of my recollection sets a bit for
>>> Cheetah...
>>
>> The later Clone kit (Multiclone) came with octagon pads. (The
>> early Clone
>> kits used a Remo practice kit with transducers added).
>
> Isn't this a wonderfully nerdy list?! ;)
>
> electronically yours, jesper
> - -- --- ---- ----- ---- --- -- -
> www.electronic-obsession.se
>
>
>
>
> ______________________________________________________________________
> __
> ______________________________________________________________________
> __
>
>
>
> ----------------------------------------------------------------------
> --
> Yahoo! Groups Links
>
>
>
>
> ----------------------------------------------------------------------
> --
>
>
>
>